Difference between revisions of "Autopilot Nosepoke Needle Holder"
From Autopilot Wiki
(Created page with "{{Schematic |Modality=Reinforcement |Schematic Type=3D CAD |Short Description=Hold an 18g Needle! |Creator=Jonny Saunders |Version=1 |Submitted Date=2021-06-28 }} {{3D CAD |.S...") |
|||
| Line 13: | Line 13: | ||
Hold an 18g needle on the back of the [[Assembled In::Autopilot Tripoke]] | Hold an 18g needle on the back of the [[Assembled In::Autopilot Tripoke]] | ||
==Fabrication Notes== | ==Fabrication Notes== | ||
| + | You will need to cut the needle to size with a dremel or a similar tool. We have had success pushing the needle through the nosepoke and marking the point where it passes through the [[Used With::Autopilot Nosepoke Cap]] and adding ~2mm. | ||
Revision as of 01:49, 4 August 2021
| Autopilot Nosepoke Needle Holder | |
|---|---|
| Modality | Reinforcement |
| Schematic Type | 3D CAD |
| Description | Hold an 18g Needle! |
| Creator | Jonny Saunders |
| Version | 1 |
| Date | 2021-06-28 |
| Repository | |
| Git Hash | |
| Used In: | Autopilot Tripoke |
| Remixes: | |
| .STL | |
|---|---|
| .STEP | |
| Other Files |
Hold an 18g needle on the back of the Autopilot Tripoke
Fabrication Notes
You will need to cut the needle to size with a dremel or a similar tool. We have had success pushing the needle through the nosepoke and marking the point where it passes through the Autopilot Nosepoke Cap and adding ~2mm.
... more about "Autopilot Nosepoke Needle Holder"