Difference between revisions of "Autopilot Nosepoke Needle Holder"
From Autopilot Wiki
(Created page with "{{Schematic |Modality=Reinforcement |Schematic Type=3D CAD |Short Description=Hold an 18g Needle! |Creator=Jonny Saunders |Version=1 |Submitted Date=2021-06-28 }} {{3D CAD |.S...") |
|||
Line 13: | Line 13: | ||
Hold an 18g needle on the back of the [[Assembled In::Autopilot Tripoke]] | Hold an 18g needle on the back of the [[Assembled In::Autopilot Tripoke]] | ||
==Fabrication Notes== | ==Fabrication Notes== | ||
+ | You will need to cut the needle to size with a dremel or a similar tool. We have had success pushing the needle through the nosepoke and marking the point where it passes through the [[Used With::Autopilot Nosepoke Cap]] and adding ~2mm. |
Revision as of 01:49, 4 August 2021
Autopilot Nosepoke Needle Holder | |
---|---|
Modality | Reinforcement |
Schematic Type | 3D CAD |
Description | Hold an 18g Needle! |
Creator | Jonny Saunders |
Version | 1 |
Date | 2021-06-28 |
Repository | |
Git Hash | |
Used In: | Autopilot Tripoke |
Remixes: |
.STL | |
---|---|
.STEP | |
Other Files |
Hold an 18g needle on the back of the Autopilot Tripoke
Fabrication Notes
You will need to cut the needle to size with a dremel or a similar tool. We have had success pushing the needle through the nosepoke and marking the point where it passes through the Autopilot Nosepoke Cap and adding ~2mm.
... more about "Autopilot Nosepoke Needle Holder"